Fujitsu ETERNUS CS800, Руководство пользователя

Страница: 236 / 604

10.3 VTL Configuration
Remote Host Select the host (initiator) to associate with the group.
You must configure a host before it is available in the Host
drop-down box (see "Remote Hosts" on page 238 ).
Target Select the target (port) to associate with the group.
The Backpanel Locations section displays a graphical
representation of the Fibre Channel and Ethernet ports as they
appear on the rear of the system. A dark border displays around the
currently selected target.
If a target is directly connected to the ETERNUS CS800,
only the directly connected ports are displayed. Otherwise,
all ports are displayed.
3. (Optional) Select the Use CCL check box to use the Command and Control LUN.
The CCL (Command and Control LUN) is not used in most environments.
This option is recommended for host access groups that contain an HP-UX
host. It can also be used if hosts that are not assigned to any host access
group exist in the SAN. The CCL is accessible to hosts only through LUN 0.
CAUTION!
If you are not sure if you should use CCL, contact Fujitsu Technology Solutions
Customer Support before you enable this option.
4. Select the check boxes for the media changer and tape drives to add to the host access
group.
The LUN assignment displays next to the device.
5. Click Apply .
Editing a Remote Host Access Group
Edit a host access group to change the CCL setting. You can also add or remove virtual
media changers or tape drives.
To edit a host access group:
1. Select the group and click Edit .
The Edit Remote Host Mapping page displays (see "Edit Remote Host Mapping Page"
on page 237 ).
If you are editing a host access group, you cannot change the Group Name ,
Partition , Host , or Target .
236 ETERNUS CS800