Fujitsu ETERNUS CS800 S6, Руководство пользователя

Страница: 371 / 561

11.4 Receive VTL
Figure 257: Failback Target Page
2. (Optional) In the Failback Destination System box, type the hostname or IP address of
a new destination system to failback the partition to. (The default destination is the
original source system.)
To use hostname format, you must specify at least one DNS IP address on
the
Network page (see "Network" on page 293 ).
3. (Optional) Leave the Use Encryption check box selected to enable encryption when
sending the snapshot to the destination. Or clear the Use Encryption check box to
disable encryption when sending the snapshot to the destination.
CAUTION!
Select 128-bit encryption if you are sending data to an ETERNUS CS800 running a
system software version prior to ETERNUS CS800 2.1 Software.
Encryption is enabled by default. However, for best performance, if your data
network is already secured, you should clear the
Use Encryption check box.
4. Click Apply .
The snapshot is sent to the source system.
5. On the source system, in the Snapshots List , select the snapshot that was sent during
the failback operation and click Recover .
The Recovered Partition Name page displays.
6. (Optional) In the Recovered Partition Name box, type a new name for the recovered
partition. (The default name is the original partition name.)
7. Click Apply .
The partition and its cartridges are recovered on the source system. All data stored on
the partition at the time the snapshot was saved is available.
ETERNUS CS800 371