Fujitsu DL3100, Руководство пользователя

Страница: 108 / 230

FUJITSU DL3100
6-4
User’s Manual
CUSTOMIZE
CUT SHEET
TOF
1. After you follow through all the steps in 6.1 or you input “
Next
”
in step 3 in 6.1, the printer prompts:
Top Margin
2. You may skip to other customized settings by pressing “ Next ” or
“ Back ”. Once you press “ OK ” to continue with customization
of cut sheet TOF, the printer prompts:
Press any key to eject current page, load paper in the Fanfold paper path,
and then proceed as follows:
[TEAR] = -(1/180) inch, [LF] = +(1/180) inch,
[LOAD/EJECT] = OK, [ONLINE] = Exit,
[ONLINE] + [LOAD/EJECT] = Save and restart the printer.
3. Follow the given prompt to unload the conversation form.
Ensure the lever is at position. Then press the [Load/Eject]
key to load fanfold paper from tractors. The top edge of the form
initially aligns with the printer’s tear-off blade. You may input
+/- 1/180 ” to adjust the TOF position. When you get the
desirable TOF, press OK or Exit . The printer prompts the
customized TOF value:
The defined position is: 4.2 mm.
Save the parameter settings
([LOAD/EJECT] or [ONLINE]=OK, [LF]=Next)?
Yes
4. At this stage:
If [Load/Eject]is pressed, an asterisk “*” is appended to “Yes”
and you should repeat the procedures for form length
measurement as mentioned. Or,
If you input “ Exit ”, the printer saves the measurement value and
proceeds with the next customized setting.