Fujitsu AOTG30KMTC, Руководство по обслуживанию

Страница: 152 / 199

7. Various control
7-1. Auto restart
When the power was interrupted by a power failure etc. during operation, the operation contents at
that time are memorized and when the power is recovered, operation is automatically started with
the memorized operation contents.
Operation contents memorized when the power is interrupted
Operation mode
Setting temperature
Fan mode setting
Timer mode and set time (set by wireless remote controller)
Airflow direction setting
Swing
ECONOMY operation
10 °C HEAT operation
Outdoor low noise operation
Remote control setting
WLAN LED setting
7-2. Test operation control
The outdoor unit may not operate depending on the room temperature.
In this case, keep on pressing the MANUAL AUTO button of indoor unit for more than 10 seconds.
The operation indicator lamp and timer indicator lamp will begin to flash simultaneously during cool-
ing test run. Then heating test run will begin in about 3 minutes when HEAT is selected by the re-
mote control operation. To end test operation, press the remote controller START/STOP button.
7-3. MANUAL AUTO operation
When the wireless remote controller is lost or battery power dissipated, this function will work without
the remote controller.
When MANUAL AUTO button is pressed more than 3 seconds and less than 10 seconds, MANUAL
AUTO operation starts as shown in the table below. To stop operation, press the MANUAL AUTO
button for 3 seconds.
Operation mode Auto changeover
Fan mode AUTO
Timer mode Continuous (no timer setting available)
Setting temperature 24°C
Vertical airflow direction louver setting Standard
Horizontal airflow direction louver setting According to memory position
SWING Off
ECONOMY Off
Human sensor Off
7-1. Auto restart
- (04-20) -
7. Various control
CONTROL AND FUNCTIONS CONTROL AND FUNCTIONS