Fujitsu Siemens Computers PRIMERGY RX100 S4, Руководство пользователя

Страница: 24 / 285

24
Chapter 1 Overview
i Hard disk access display LED ( )
This LED is on in green when data is being written to or read from the hard disk.
j Front maintenance LED ( )
This LED turns on or blinks in amber when an error is detected in the server components.
If this LED is on or blinking, contact an office listed in the "Contact Information" of "Start
Guide".
k Power LED ( )
This LED is on in green when the server is turned on.
This is on in amber when the server is not turned on (standby mode).
This does not turn on when the power cable is unplugged from the outlet.
1.3.2 Server (Rear View)
a Inlet
AC power cables are plugged in.
b USB connector ( )
Connects peripheral equipment conforming to the USB standard (2.0 or 1.1).
c LAN connector 2 ( )
An Unshielded Twisted Pair (UTP) cable is plugged in. For 1000Mbps connection, a cable
conforming to category 5 enhanced is required.
The meanings of the two LEDs are shown in the table below.
table: LAN connector LED
LED
location
LED status LAN status
Left ON (green) Link is being established.
Blinking (green) Data is being transferred.
OFF Link is not established.
Right ON (amber) Connection is established at
1000Mbps.
ON (green) Connection is established at 100Mbps.
OFF Connection is established at 10Mbps.
a b d
i
j
c e f g h
2
LED LED