Fujitsu Siemens Computers CELSIUS MOBILE 810, Руководство по эксплуатации

Страница: 56 / 82

Troubleshooting and tips
46
A26391-K82-Z110-1-7619
Error messages on the screen
In the following the error messages are described which are output by the system BIOS (see BIOS
Setup manual). Error messages displayed by the operating system or programs are described in the
relevant manuals.
Diskette read failure - press F1 to retry boot
The inserted system disk is defective
Ê Insert another system disk.
Ê
Press function key
[F1]
[F1] [F1]
[F1]
.
No boot device available - press F1 to retry boot
The operating system cannot be loaded
Ê
Insert a system disk.
Ê
Press function key [F1] [F1] [F1] [F1] .
No boot sector on fixed disk - press F1 to retry boot
The operating system is not installed on the hard disk or the hard disk has not been formatted.
Ê
Insert a system disk.
Ê Press function key [F1] [F1] [F1] [F1] .
Not a boot disk - press F1 to retry boot
The disk in the floppy drive is not a system disk.
Ê
Remove the floppy disk from the drive.
Ê
Press function key
[F1]
[F1] [F1]
[F1]
.
If you wish to boot from floppy disk:
Ê Insert a system disk.
Ê
Press function key [F1] [F1] [F1] [F1] .
Real time clock failure
Invalid configuration information - please run setup program
Press the F1 key to continue, F2 to run the setup utility
The system configuration information is incorrect.
Ê
Press function key [F2] [F2] [F2] [F2] .
Ê If the time and date are incorrect, set them correctly.
Ê
Reconfigure the system.
If the error message occurs repeatedly, then the buffer battery in the workstation is dead. Connect
the workstation via its power adapter to a grounded wall outlet or install a fresh battery. The buffer
battery will take approximately two days to complete its recharge.