Fujitsu Siemens Computers CELSIUS MOBILE 810, Руководство по эксплуатации

Страница: 55 / 82

Troubleshooting and tips
A26391-K82-Z110-1-7619
45
The floppy disk cannot be written
Ê Check whether the floppy disk is OK and is not write-protected.
The workstation's date or time is incorrect
Ê
Set the time and/or date in the BIOS Setup menu Main .
i
If the date and time are repeatedly incorrect when you switch on the workstation, the
buffer battery that supplies the internal clock is dead. Connect the workstation via its
power adapter to a grounded wall outlet or install a fresh battery. The buffer battery will
take approximately two days to complete its recharge. Should the problem persist, please
contact your Service provider.
The printer does not print
Ê
Make sure that the printer is switched on and is on-line (see the manuals supplied with the
printer).
Ê
Check that the cable connecting the workstation and the printer is connected properly.
Ê
Check that the correct printer driver is installed.
Ê Check in the
BIOS setup
whether the parallel port is activated and correctly set in the
Advanced
Setup - I/O Device Configuration - Parallel Port field. The respective entries in the fields of Serial
Port
or
Parallel Port
must match the setting in the application program under Windows.
Acoustic warnings
A beep sounds every few seconds
The battery is almost flat.
Ê
Charge the battery.
A single continuous beep
The workstation cannot switch to standby or suspend mode because hard disk or diskette accesses
take place or there is no space provided on the hard disk.
Ê
Wait until the hard disk or diskette accesses have terminated, or set up the required storage
space on the hard disk.
Three long beeps
The workstation cannot restore the programs that were active when it switched to Suspend mode.