Fujikura FSM-60S, Инструкция по эксплуатации

Страница: 62 / 119

60
Splice Menu
Splice Mode Description
SM
For splicing standard Single-mode fiber (ITU-T G652).
The MFD is 9 to 10 um at wavelength of 1310 nm.
Automatic arc calibration doesn’t work in this splice mode.
NZ
For splicing Non-zero dispersion-shifted fiber (ITU-T G655).
The MFD is 9 to 10 um at wavelength of 1550 nm.
Automatic arc calibration doesn’t work in this splice mode.
DS
For splicing Dispersion-shifted fiber (ITU-T G653).
The MFD is 7 to 9 um at wavelength near 1550 nm.
Automatic arc calibration doesn’t work in this splice mode.
MM FAST
For splicing Multi-mode fiber (ITU-T G651).
Core diameter : 50.0 to 62.5 um
Automatic arc calibration does not work in this mode.
AUTO mode uses this splice condition with the automatic calibration
when splicing MM fibers.
By using this mode, occurrence of bubbles is low even if the cleaver
or electrode condition is not good, but the appearance of splice point
may appear slightly fat. If a bubble still occurs, use the MM-MM
mode, and increase [Prefuse Time] and [Prefuse Power].
SM AUTO
For splicing standard Single-mode fiber (ITU-T G652).
The MFD is 9 to 10 um at wavelength of 1310 nm.
Automatic arc calibration works in this splice mode.
NZ AUTO
For splicing Non-zero dispersion-shifted fiber (ITU-T G655).
The MFD is 9 to 10 um at wavelength of 1550 nm.
Automatic arc calibration works in this splice mode.
MM AUTO
For splicing Multi-mode fiber (ITU-T G651).
Core diameter : 50.0 to 62.5 um
Automatic arc calibration works in this splice mode.
DS AUTO
For splicing Dispersion-shifted fiber (ITU-T G653).
The MFD is 7 to 9 um at wavelength of 1550 nm.
Automatic arc calibration works in this splice mode.
Other splice
modes
There are many types of splice modes in this splicer, other than the
ones stated above, stored in the splicer database. Select a “BLANK”
splice mode, and press Menu key
.
Then press Enter key
.
Nearly 60
splice modes stored in the database are displayed. Select one splice
mode to be used.