FujiFilm SonoSite Edge Stand, Руководство пользователя

Страница: 11 / 256

En
glish
De
utsch
Español
Fr
a
n
ça
is
It
a
lia
n
o
Po
rt
u
g
u
ê
s
Troubleshooting 9
English
De
ut
sch
Español
Fr
a
n
ç
a
is
Ita
lia
no
P
o
rtuguês
Nederlands
To remove the TTC
1 Remove any attached transducers.
2 Disconnect the transducer connector from the system.
3 Pull out the knob on each of the two mounting brackets, and slide the TTC out.
Troubleshooting
Connectivity diagram
Use the following diagram for assistance disconnecting and reconnecting peripherals. For more detailed
information, refer to the assembly instructions. Additional copies are available at
www.sonosite.com .
See also “Cables and connectors” on page 10.
Symptom Solution
Printer does not print.

Check the printer selection on the Connectivity setup page.
See the ultrasound system user guide.

Check the cable connections. See the printer installation instructions.

Ensure that the printer is turned on and set up properly. See the printer
manufacturer’s instructions, if necessary.
Stand tips over more easily
than expected.

Lower the platform on the stand.

Avoid placing heavy objects on the platform. Too much weight on the
platform can cause the stand to become less stable.
Caution To avoid damaging the system, use only accessories and peripherals recommended
by SonoSite
with the ultrasound system.