FujiFilm PXG4, Инструкции по эксплуатации

Страница: 81 / 158

– 80 –
8
Chapter
Remote SV Zero Adjustment ,
Remote SV Span Adjustment
This function adjusts remote SV zero/span.
Use this function to match zero/span to an output gauge.
• Range: -50.0% to 50.0% FS (zero/span)
Zero/span adjustments for input in the 1-5V range are as
follows:
Adjusting Remote SV Zero/Span
The following steps explain how to adjust remote SV zero/
span by using a zero deviance of -5% and a span deviance of
7% as an example.
1
Confirm the accuracy of the SV display by
checking the PV display when the mV generator
or dial resistor is set to 0 and 100%.
The zero display deviance is -5% and the span
display deviance is 7%.
Refer to
See "Remote SV (RSV) Pin Input Display" (p. 66) for more
information on confirming remote SV.
2
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
3
Set the input from the mV generator to 0%.
4
Press and hold the key, then use the
keys to display rEM0 ("
rrr rEEEEMMMM0000
").
RSV display
zero adjustment
span adjustment
input
100%
5V
1V
0%
5
Press the key, then use the keys to
select 5.0 when the bottom part of the display
begins to blink.
The zero display deviance is -5%, so the correction is
5.0%.
6
Press the key to confirm the setting.
7
Set the input from the mV generator to 100%.
8
Press and hold the key, then use the
keys to display rEMS ("
rrr rEEEEMMMMSSSS
").
9
Press the key, then use the keys to
select -7.0 when the bottom part of the display
begins to blink.
The span display deviance is 7%, so the correction is
-7.0%.
10
Press the key to confirm the setting.
11
Press the key to return to the operation mode
PV/SV display.