FujiFilm PXG4, Инструкции по эксплуатации

Страница: 59 / 158

– 58 –
6
Chapter
Ramp/Soak SV Select (step1) to (step16) ,
Ramp Time (step1) to (step16) ,
Time Soak (step1) to (step16)
to
to
to
The following sets ramp/soak SV, ramp time and soak time.
The range for each is shown below.
• Both ramp time and soak time skip segment 0.
[Example]
SV-1 : 50 SV-2 : 200 SV-3 : 100
TM1r : 0.10 TM2r : 0.00 TM3r : 1.00
TM1S : 0.05 TM2S : 0.00 TM3S : 0.75
• The SV limit function (SV-h, SV-L) is still on while ramp/
soak is running.
The set value (SV-n) does not change, but the value is
limited during ramp/soak. For that reason, the value may not
change at the set times for the following patterns.
Setting Ramp/Soak SV, Ramp Time and Soak Time
SV
SV lower limit (SV) to
SV upper limit (SVh) %FS
Ramp time 00:00 to 99:59 (hour:min/min:sec)
Soak time 00:00 to 99:59 (hour:min/min:sec)
SV-1
SV-2
step 2 soak time (TM2s)
SV
step 1 ramp time (TM1r)
step 1 soak time (TM1s)
step 2 ramp time (TM2r)
100
200
50
SV
TM1r TM1S TM3r TM3S t
SV-2
SV-h
SV-L
SV-1
SV
t
program pattern
PV
SV-3
TM1r TM1S TM2r TM3r TM2S
pattern with
SV limit applied
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh1111
"), then use the
keys to display PrG ("
PPP
PrrrrGGGG CCCChhhh 4444
").
Refer to
See p. 56 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to display Sv-1 ("
SSS Svvvv----1111
").
Set the goal for the step 1 SV value.
3
Press the key, then use the keys to
select 200.0 when the bottom part of the display
begins to blink.
The value is set to 200.0°C.
4
Press the key to confirm the setting.
5
Repeat steps 2-4 (excluding pressing and holding
the key) to specify the ramp and soak times.
Repeat the necessary steps to set other variables.
6
Press the key to return to the operation mode
PV/SV display.