FujiFilm PXG4, Инструкции по эксплуатации

Страница: 117 / 158

– 116 –
10
Chapter
Load short-circuit alarm setting
Load short-circuit alarm hysteresis
These are the functions to detect short-circuiting of the
SSR or SSC. They are valid only for the ON/OFF (two
positions) control.
The setting items of the load short-circuit alarm are as
follows:
Setting the Load Short-circuit Alarm Timing
This section describes how to set the load short-circuit alarm
setting to "4A" and the hysteresis to "1.2A".
Load short-
circuit alarm
setting Sets the electrical current value at which to
detect a load short-circuit alarm.
• Range: 0.0 to 50.0A
Load short-
circuit alarm
hysteresis Sets the space between the detection and
restoration of the load short-circuit alarm.
• Range: 0.0 to 50.0A
1
Display the setup mode channel menu ("
ooo
oPPPPEEEE CCCChhhh
111 1
"), then use the keys to display ALM
("
AAA
ALLLLMMMM CCCChhhh8888
").
Refer to
• See p. 113 in this chapter for information on how to
display the channel menu.
• See "USER Key Assignments" for more about setting
the USER key (p. 93).
2
Press and hold the key to display alarm
hysteresis 1 ("
AAA A1111hhhhyyyy
"), then use the keys to
display load short-circuit alarm setting hS1
("
hhh hSSSS1111
").
3
Press the key, then use the keys to
set the hysteresis to "4.0" when the bottom part
of the display begins to blink.
The load short-circuit alarm setting is set to "4.0A".
4
Press the key to confirm the setting.
5
Use the keys to display load short-circuit
alarm hysteresis hS1h ("
hhh hSSSS1111hhhh
").
Set the hysteresis of the load short-circuit alarm.
6
Press the key, then use the keys to
set the hysteresis to "1.2" when the bottom part
of the display begins to blink.
The load short-circuit alarm hysteresis is set to
"1.2A".
7
Press the key to confirm the setting.
8
Press the key to return to the operation mode
PV/SV display.