FujiFilm PXG4, Инструкции по эксплуатации

Страница: 100 / 158

– 99 –
9
Chapter
Ramp SV ON/OFF ,
Ramp SV decline ,
Ramp SV incline ,
Ramp SV slope time unit
This function changes a previously set SV to the new
value at the ramp rate.
SV does not change stepwise, but smoothly. Incline and
decline rates can be set independently.
• Setting range
Ramp SV-incline/decline: 0% to 100% FS/°C
Ramp SV slope time units - hoUr (Slope deg/hr)
- Min (Slope deg/min)
Operation is as follows for changing SV.
Setting Ramp SV
The following steps explain how to set ramp SV by using incline
= 10°C/min and decline = 5°C/min as an example.
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SYS ("
ooo
oPPPPEEEE CCCChhhh 7777
").
Refer to
See p. 93 in this chapter for information on how to display
the channel menu.
2
Use the keys to display rMP ("
rrr rMMMMPPPP
").
3
Press the key, then use the keys to
select on when the bottom part of the display
begins to blink.
The ramp SV set on.
t
SV changes at the
specified ramp rate
SV
SV change
4
Use the keys to display rMPL ("
rrr rMMMMPPPPLLLL
").
5
Press the key, then use the keys to
select 5.0 when the bottom part of the display
begins to blink.
The decline is now 5°C/min.
6
Press the key to confirm the setting.
7
Set the ramp SV incline to 10°C/min.
8
Use the keys to display rMPU ("
rrr rMMMMPPPPUUUU
").
9
Press the key, then use the keys to
select "Min".
The time unit is deg/min.
10
Press the key to return to the operation mode
PV/SV display.
Point
The ramp operation becomes as follows depending on the
setting range of "rMPL" and "rMPh".
Other than "0": The ramp operation setting is enabled.
"0": The ramp operation ends, or ramp operation is not
performed.