FujiFilm FUJINON HA14x4.5 BEZD-T58B, Руководство по эксплуатации

Страница: 51 / 108

- 1 3 -
Either side of the zoom limit positions can be set at first.
The wide side zoom-limit position cannot be set
to the same position as the tele side zoom-limit
position, or further toward the tele end than the
tele side zoom-limit position.
This is the same with the tele side.
In re-setting the zoom limit positions, if it is
required to set a limit position beyond the pre
-
viously set zoom limit position, move the zoom
by taking either way following.
The zoom limit positions will be held even if the
zoom limit ON/OFF select switch is set to
“OFF” or the power to the lens is turned
“OFF.”
Note 1.
Note 2.
Note 3.
Note 4.
■ Zoom Limit Operation
Before performing a zoom limit operation, if the zoom position is not within the range of the tele
side and the wide side zoom limit positions, when the seesaw control lever is operated, the zoom
will move only toward the zoom limit positions, not toward the opposite side of them.
If a zoom rate demand unit that has the zoom limit function is connected to the lens, the validity of
the zoom limit function differs depending on the type (digital or analog) of the zoom rate demand
unit.
Note 1.
Note 2.
If the quickframe/manual zoom select knob is set to “OFF,” change it to “ON.”
If the zoom limit ON/OFF select switch is set to “OFF,” change it to “ON.”
By means of the zoom seesaw control lever, operate the zoom.
Keep pressing the “T” side of the lever so that the zoom reaches the tele side zoom limit position and
stops.
Keep pressing the “W” side of the lever so that the zoom reaches the wide side zoom limit position and
stops.
a.
b.
c.
With a digital zoom rate demand unit, the zoom limit function of the zoom rate demand unit
will be valid. The zoom limit function of the lens will not work.
With an analog zoom rate demand unit, the zoom limit functions of both the zoom rate
demand unit and the lens will be valid. To avoid a confusion of the zoom limit positions,
turn off the zoom limit function of one of them.
・
・
■ Setting of Zoom Limit Positions
・ Before shipment at the factory, the zoom limit positions were set at the tele end and the wide end respectively.
If the zoom limit ON/OFF select switch is set to “OFF,” change it to “ON.”
Move the zoom in the manual or the servo operation (refer to Note 3), and stop it at the position
desired as a tele side zoom limit position.
Press the zoom limit switch (T) for more than one second.
─ The tele side zoom limit position will be set.
Move the zoom in the manual or the servo operation (refer to Note 3), and stop it at the position
desired as a wide side zoom limit position.
Press the zoom limit switch (W) for more than one second.
─ The wide side zoom limit position will be set.
Rotate the zoom ring in the manual opera-
tion.
Pressing the zoom limit switch on the side of
the new zoom limit position to be set,
operate the zoom in the servo operation.
・
a.
b.
c.
d.
e.
Tele End
Zoom Operation Range
Wide End
Tele End
Wide End
Zoom-limit setting position
(wide side)
Zoom-limit setting range
(tele side)
Zoom-limit setting range
(wide side)
・
(tele side)
Zoom-limit setting position
(wide side)
(tele side)
Zoom Operation Range