FujiFilm FUJI DRI-CHEM NX600, Инструкция по эксплуатации

Страница: 115 / 268

5-9 897N203029A FDC NX600 Instruction Manual 2022.01
5 Loading Consumables
5.5 Loading Reference Fluid
Reference fluid is necessary for ISE measurements. (Refer to Section 3.5).
WARNING:
When handling reference fluid, follow biohazard procedures (wear gloves, a lab coat, and safety
goggles) in accordance with the medical handling rules of your facility. If you accidentally touch an
item, immediately rinse the contaminated body part thoroughly under running water.
WARNING:
Discard reference fluid according to the medical handling rules of your facility and related laws.
WARNING:
During sample application, tap the [STOP] button to stop application, and then load the reference
fluid. Loading is unsafe during sample application because the sampler and the consumable disk
are moving.
IMPORTANT:
Use a FUJI PLAIN TUBE (0.5 or 1.5 mL) for reference fluid. Otherwise, measurement errors or
malfunctions may occur.
Configure the type of container to be used via [Tube setting for diluent & reference fluid] in Mode
function for administrator (Refer to Section 9.3.15).
IMPORTANT:
Replace FUJI PLAIN TUBES (1.5 mL) within 24 hours.
Replace FUJI PLAIN TUBES (0.5 mL) for each measurement.
0.5
0.3
0.1
FUJI PLAIN TUBE
(1.5 ml)
Pour reference fluid
within the range.
FUJI PLAIN TUBE
(0.5 ml)
0.5
1.0
1. Prepare reference fluid.
Pour the following amounts into each type of
FUJI PLAIN TUBE.
For 1.5 mL tube: 1.0-1.5 mL
For 0.5 mL tube: 0.3-0.5 mL
NOTE Use reference fluid after it reaches room
temperature.
2. With [Warming up] or [Ready to test] dis-
played on the LCD, make sure that the
analyzer is not applying samples.
5