FujiFilm Frontier 570, Инструкция по эксплуатации

Страница: 103 / 146

103
FMPC
8.2.20 Image Position Fine Adjustment
(458)
[Selection]
“4 Setup and Maintenance” - “5 Printer Adjustment/
Maintenance” - “8 Image Position Fine Adjustment”
[Procedure]
Adjustment of the image position for each paper
magazine.
1
Make a bordered print to be adjusted.
2
Select the paper magazine for print to be
adjusted.
3
Check that the image is in the center of paper.
4
If necessary, adjust by following the steps below.
(1) In Menu 424 “Print Size Setup”, enter initial
bordered width (4.0mm or 5.0mm) in “Upper
BD”, “Lower BD”, “Left BD” and “Right BD”
columns.
(2) To move the image in the feed direction,
decrease the value in the “Sub-scanning” (Y).
(3) To move the image in the reverse direction,
increase the value in the “Sub-scanning” (Y).
(4) To move the image in the rear direction,
decrease the value in the “Main scanning” (X).
(5) To move the image in the front direction,
increase the value in the “Main scanning” (X).
NOTE:
Adjusting Range: – 30mm to 30mm
5
Click [Set].
6
Click [End].
• Operation returns to the “4 Setup and
Maintenance” screen.
8.2.21 Printer Function Select
[Selection]
“4 Setup and Maintenance” - “5 Printer Adjustment/
Maintenance” - “8 Printer Function Select”
[Procedure]
Set up the printer function such as magazine
operation setting.
distributed by www.minilablaser.com