FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 196 / 628

MU1-31
MU1-31
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
u
NOTE
u
- In the beginning when afterimage calibration is implemented, record the
exposing conditions, and subsequently be sure to expose with the same
conditions.
This is for comparing the afterimage amounts over time, so that SE (FPD)
degradation analysis can be done in advance.
- If 100mR or greater irradiating cannot be performed via conditions with a
80kV tube voltage, and maximum irradiating times of 200 ms, then close the
distance between the X-ray tube and the panel as much as possible (to the
limit whereas the entire panel will be irradiated by the X-rays).
Nevertheless, if 100mR or greater irradiating cannot be performed, raise the
tube voltage up to 100kV. With these conditions, if the irradiating is 20mR or
greater, implement the afterimage correction calibrating.
If the aforementioned conditions do not reach 20mR or greater, the afterimage
correction calibrating needs to be implemented via another X-ray device.
When the log correction data is automatically generated and stored in the HDD,
“Succeeded” appears after completion.
u
NOTE
u
If “NG” appeared, check the following.
- Exposure condition
- Exposure field is the entire SE.
(4) Click [OK].
1.4.2 Long Panel Calibration
Used to make the following calibration on the DR-ID 1305SE.
Refer to the Installation manual for the detailed procedures.
{IN1:11._Image Calibration}
{IN1:12._Marker Calibration}
- Offset Calibration
- Gain Calibration
- Defect Calibration
- Lag Calibration
- Long Panel Calibration
u
INSTRUCTION
u
Check to make sure that background calibration (which takes place automatically
when the MC is started) is completed before carrying out the following calibration.
The image correction data cannot be correctly performed if the calibration takes place
while the background calibration is in progress.
- Offset Calibration
- Gain Calibration
- Defect Calibration
- Lag Calibration
- Long Panel Calibration
You can check whether background calibration is completed on the status lamp
“READY” of the SE
- While background calibration is in progress:
“READY” is flashing.
- While background calibration is not carried out:
“READY” is unlit.
u
NOTE
u
When performing the calibration with the FIPS MODE set to “ON” in the
CONFIG
SETTING
, a warning message is displayed to indicate that the data transfer rate is
slow. Set the FIPS MODE to “OFF” or perform the calibration after wire-line connecting
the SE.