FujiFilm DR-ID 1300, Руководство по обслуживанию

Страница: 136 / 628

MC-23
MC-23
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-02E
3.1.3 RMV65A Board
n
Removal Procedures
(1) Remove the SE rear cover.
{MC:3.1.1_SE Rear Cover}
(2) Remove the RMV65A board.
#1 Disconnect: Cable connectors (RMV1, 3, 4, 11, 12, 16, 19-25, 27, 28)
#2 Remove: M2.6x3 (x6)
SE
1300_300010.ai
RMV22 RMV21
RMV25 RMV12
RMV11
RMV23
RMV24
RMV20
#2
RMV16
#1
RMV4 RMV65A board
RMV19
RMV1 RMV3 RMV27 RMV28
u
NOTE
u
- Cables are connected to the cable connectors of RMV11 and 12 only on the
RMV65A board for the CENTER panel unit.
- The cable connectors of RMV4 on the RMV65A boards for the TOP and
BOTTOM panel units are hidden under the harness, so remove the boards
before removing the cable connectors.
n
Reinstallation Procedures
(1) Reinstall the RMV65A board.
Reverse the removal procedures for reinstallation.
(2) Reinstall the SE rear cover.
{MC:3.1.1_SE Rear Cover}
(3) For the two panel units whose RMV65A boards have not been
replaced, transit to the ExtraSleep mode.
(4) Input the SE serial ID of the panel unit whose RMV65A board was
replaced.
REFERENCE
Input the serial ID only after the RMV65A board is replaced.
I.
Start up the MUTL.
II.
Click [BOARD STATE CHECK] and click [SE Write Serial ID>>].
#1 Click: [BOARD STATE CHECK]
#2 Click: [SE Write Serial ID]
1300_300022E.ai
#1
#2