FujiFilm ClearView CS, Руководство по обслуживанию

Страница: 519 / 1404

CR-IR 363
Service Manual
MC-30
MC-30
011-202-11E
06.29.2012 FM6046
4.16 PSU29A Board (#50001 or Later)
{SP:INDEX}
CAUTION
When servicing any printed circuit board, be sure to wear an anti-static
wristband to ground your body. If your body is not grounded, static electricity
built on your body may cause damage to electronic parts on the board.

Removal Procedures
1.
Remove the Power Supply Assembly.
{MC:4.14 _Power Supply Assembly (#50001 or Later)}
2.
Release the clamp, and disconnect the connectors.
3.
Remove the screws.
4.
Remove the PSU29A board.
u
NOTE
u
To remove the PSU29A board, tilt it out. Otherwise, the retention clips might be
damaged.

Reinstallation Procedures
For reinstallation, reverse the removal steps.
Measure the voltage in accordance with the table in “
l
#50001 or Later and #60001 or Later”.
{MT:8.2.2 _Checking the Voltage on Test Pins}
{MT:8.3.2 _Checking the Voltage on Test Pins}
{MT:8.5.2 _Checking the Voltage on Test Pins}