Fujian Xingyi Polishing Machine Co.,Ltd
Manual Of Remote Control Floor Grinder 800-4E
Factory Addresss:NO.C2 ,Area 11 ,AnPing Development Area, Quanzhou ,Fujian province ,China
Postal Code:362200
Tel: +86-595-36792992
Mob: +86-15960788816
Use only Xingyi parts and accessories, For your own safety, The Safety of others and the life of your machines.
48
5.3 Star and stop grinding machine
Adjust additional weight, swing bar, hand grip to relative working position, spinning
supporting wheel to lowest position and turn around forward, or unload it.
1
、
When starting, should change swing bar to remote state, spinning the button to turn
on the emergency switch on the swing bar.Turn on the power switch of the control
panel,spinning to turn on emergency switch, use the handle to adjust the machine
direction.Turn the switch to left then grinding machine forwards, turn to right the motor turn
to reverse, then turn on the machine. Use the handle to control the machine direction.
2
、
Stop grinding machine:press emergency switch , pls turn power switch of the control
panel to OFF, then machine stop(remember to reset the reverse and forward of the motor.)
Note:
1
、
When machine stop, for safety, pls take off the power plug.
2
、
Emergency switch only could spinning and press downward as above, could not pull
out outward.
3
、
When machine start to operate, pls note reset all switch of the remote controller, keep
the good condition to normal using, or if turn on the power, machine would not run.
4
、
When using remote controller , remote controller could not leave the normal usage
area, we could focus on the sigh light of the remote controller, if the distance is tool far,
we are unable to control the machine.
5
、
Turn on the power of the ejector , to check the power light is slowly flash or not, if
not,adjust the ejector.
6
、
We could not stir the direction rocker until grinding plate drive motor start to run.
7
、
When machine need to stop the machine or emergency situation, turn on the
emergency switch of the ejector.
