Fuji Xerox DocuPrint CM505 da, Руководство администратора

Страница: 46 / 599

2 Paper and Other Media
46
P
ape
r a
nd O
the
r M
edia
2
Note • If the envelopes are still not loaded
correctly, add some bending to the lead
edge of the envelopes as shown in the
illustration.
• The amount of the bending should be
5mm or less.
Loading Paper in Tray 5 (MSI)
When printing or copying on a size or type of paper that cannot be set in Trays 1 to 4,
use Tray 5. The following describes the procedures to load paper in Tray 5. For
printings, specify the instructions using the [Paper/Output] tab in the print driver. Also
specify the type of paper to be loaded.
Important • To prevent paper jams and erroneous detection of paper loaded in the tray by the machine,
do not take out paper of a package until the tray runs out of paper.
Note • Carefully fan the paper before loading it in a tray. Otherwise, the paper may stick together,
resulting in paper jams, or multiple sheets being fed to the machine simultaneously.
1
Open Tray 5.
2
Slide the width guides to the edge of the
tray. The width guides should be fully
extended.
3
Load paper with the side to be copied or
printed on facing down, inserting the paper
until its edge lightly touches against the
paper feed entrance.
Important • Do not force paper into Tray 5.
• Do not load mixed paper types into the
tray.
• Do not load paper above the maximum fill
line. It may cause paper jams or machine
malfunction.
• Depending on the type of the
heavyweight paper, paper may not be fed
to the machine or image quality may
deteriorate.