Fuji Xerox DocuPrint CM505 da, Руководство администратора

Страница: 172 / 599

5 Tools
172
T
ools
5
„ Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1 minute
increments.
„ Login Name
Enter the name to login to the POP3 server with up to 64 characters.
„ Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
„ POP Password Encryption
Select [On (APOP)] to encrypt the password.
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items:
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
„ SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.
„ SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
„ E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
Note • If [POP before SMTP] is selected, the POP3 settings must be set.
• AUTH PLAIN, AUTH-LOGIN, or AUTH CRAM-MD5 can be used as an authentication
method.
„ Login Credentials for E-mail Send
Select the login user name when sending e-mails from [Remotely Authenticated User] or
[System]. When [Remotely Authenticated User] is selected and if the machine tries
authenticating the remote server before a job startup, the machine performs verification at the
time of transmission with the remotely authenticated user name and password. You can also
select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin using
System Data]. If you do not set remote authentication, the machine uses the user ID and
passcode of the machine for authentication.
„
SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
„ SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note • If you do not set the password, leave the text boxes blank and select [Save].
Remote Authentication / Directory Service
You can make the settings for the remote authentication server and directory service.
Note • "LDAP Server / Directory Service Settings" (P.173).