Fuji Xerox DocuPrint CM505 da, Руководство администратора

Страница: 166 / 599

5 Tools
166
T
ools
5
ThinPrint
„ Port Status
You can use the machine for print in the ThinPrint.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
„ Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note • ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.
„
Auto
Select this to detect the Ethernet transmission rate automatically.
„ 100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
„ 100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
„ 10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
„ 10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
„ 1000 Mbps
Select this to set 1000BASE-T as the default value.
TCP/IP - IP Mode
Allows you to select the TCP/IP operation mode.
„ IPv4 Mode
Select this option for IPv4.
„ IPv6 Mode
Select this option for IPv6.
„
Dual Stack
Select this option for an environment using both IPv4 and IPv6.
IPv4 - IP Address Resolution
Allows you to select a method for obtaining the IP address, subnet mask, and gateway
address.
„ DHCP
The address, subnet mask, and gateway address will automatically be set via DHCP.
„ BOOTP
The address, subnet mask, and gateway address will automatically be set via BOOTP.