Fuji Xerox DocuPrint CM225FW, Руководство пользователя

Страница: 231 / 344

Using the Operator Panel Menus and Keypad 231
Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 32
Values:
Show Paper Size/Type Error
Purpose:
Specifies whether to use paper of a different size when the paper that is loaded in the standard 150 sheet tray does
not match the paper size settings for the current job.
Values:
• Timers
Purpose:
To configure timer settings.
Control Panel
Purpose:
To specify the time for the printer to automatically return to the standby mode. When the setting is not complete in
the specified time, the previous setting is restored.
Values:
Fault Timeout
Purpose:
To specify the amount of time the printer waits before canceling a job that stops abnormally. The print job is canceled
if the time-out time is exceeded.
Values:
Start
Performs the initial settings for the printer.
On
Shows the alert message when the paper size loaded in the tray is different from
the paper size set for the current job.
On(except A4/Ltr)
* Shows the alert message except for the time A4 size paper is loaded in the tray
and letter size is set for the current job and for the other way around.
Off
No tray size substitute accepted.
45 seconds
*
1 Minute
2 Minute
3 Minute
4 Minute
Off
Disables the fault time-out.
On
*
60 sec
* Sets the amount of time the printer waits before canceling a job that stops
abnormally.
3–300 sec