Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 148 / 556

4 Fax
146
Fax
4
It is necessary to assign the primary relay station and secondary relay station Address
Numbers in advance, as shown below.
Important • When using the F Code method for remote Relay Broadcast Send, the primary relay stations
and secondary relay stations must support our F Code method and be equipped with the
Relay Broadcast feature.
Note • When performing Relay Broadcast Send with machines of this model, we recommend using
the fax signal method.
When using the machine as a relay station, the F Code that is transmitted to the
initiating station is as follows.
„
Relay Broadcast
Number of digits of primary relay station
1: For primary relay station IDs and Address Numbers that are 2 digits
2: For primary relay station IDs and Address Numbers that are 3 digits
„
Print Command
Existence of printing at the primary relay station
1: Printing at the primary relay station
0: No printing at the primary relay station
„
Primary Relay Station ID
The Address Number for the initiating station registered at the primary relay station.
When the primary relay station ID is set, the initiating station is notified of the results of
the remote Relay Broadcast Send.
When the relay station ID is "00" or "000", the initiating station is not notified of the
results of a remote Relay Broadcast Send.
Where Contents
Primary
Relay
station Assign the initiating station either an Address Number from 001 to 500 (when
the specification method for the initiating station is 3 digits in F Code) or 001 to
099 (when the specification method for the initiating station is 2 digits in F
Code). Then, set Relay Station Setup of the Address Number to [On].
Assign the secondary relay station either an Address Number from 001 to 500
(when the specification method for the initiating station is 3 digits in F Code) or
001 to 099 (when the specification method for the initiating station is 2 digits in
F Code).
z
As the relay station ID, assign the last two digits of the Address Number for
the primary relay station that is registered to the secondary relay station.
z
As the broadcast recipients, assign the Address Number for the relay
recipients that have been registered to the secondary relay station.
Secondary
Relay
station Assign the primary relay station the same Address Number as that of the
initiating station registered at the primary relay station, and set Relay Station
Setup of the Address Number to On.
Assign the relay recipients either an Address Number from 001 to 500 (when
the specification method for the initiating station is 3 digits in F Code) or 001 to
099 (when the specification method for the initiating station is 2 digits in F
Code).
Relay Broadcast
Send Print
directive First relay
station ID Address
Number Address
Number Address
Number
....
Up to 20 digits