Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 118 / 556

4 Fax
116
Fax
4
Specifying Destination Using the Keyboard Screen
When the G3 kit (optional) is installed, you can set the line (port) and send faxes.
1
Select [Keyboard] on the [Basic
Features] screen.
2
Enter "<", "port number", ">", and
"telephone number" with the
keyboard that appears on the touch
screen.
3
Press the <Start> button.
Note • The port numbers are "1", line 2 (LINE 2 jack)
J
"2" and line 4 (LINE 4 jack)
J
"4".
• You can specify line 2 and 4 when an option is installed.
Entering Specific Symbols
When specifying a recipient, you can use the following features to enter specific
symbols from the touch screen.
Note • When using the DTMF method, use specific symbols. For information about the DTMF
method, refer to "Broadcast" (P.140).
Feature Button Action Input method
Enter pause - or pause
(-) One pause is 3 seconds.
You can enter pauses of 6
seconds, 9 seconds, etc. by
additional button presses. Press the Pause button.
(Example)
0-123...
0- -123...
Transmit
using a password S Use a password to prevent
transmission errors.
When a password has been
set, transmission will only
start if the password
matches the ID number on
the remote terminal. 1. Select the Keyboard
button in the Basic
Features screen to
display the keyboard.
2. Select the PQRST
button and the Shift
button.
3. Select the S button.
(Example)
0312345678S12345678
Transmit
DTMF signal ! Use to transmit the DTMF
signal. 1. Select the Keyboard
button in the Basic
Features screen to
display the keyboard.
2. Select the Symbol
button.
3. Select !.
(Example)
0311123456!123#
Transmit PB
(from dial pulse to
tone) : Switches the dial type from
pulse to tone when the Fax
service is used. 1. Select the Tone (:)
button on the On-hook
or Off-hook screen.