Configuration of Scan to Mailbox
95
U
sin
g
Sc
an
Ser
vice
11
7) Select [Close] repeatedly until the [Network Settings] screen is displayed.
z
When using application software supporting the WebDAV protocol provided by Fuji
Xerox, such as EasyOperator.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [WebDAV], and then select [Change Settings].
5) Select [WebDAV - Port Status], and then select [Change Settings].
6) Select [Enabled], and then select [Save].
7) Select [Close] repeatedly until the [Port Settings] screen is displayed.
8) Enable [Internet Services (HTTP)] in the same manner as above.
9) Select [Close] repeatedly until the [Network Settings] screen is displayed.
3
Set an IP address.
If the IP address is already set, this step is not necessary. Also, in an environment with
DHCP or BOOTP, configure the way to obtain the address. Either the address cannot
be obtained automatically or manual configuration is preferred, configure the IP
address, subnet mask, and gateway address.
1) Select [Protocol Settings].
2) Select [TCP/IP - Get IP Address] and then select [Change Settings].
3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual] and then
select [Save]. If you select anything other than [Manual], proceed to step 5.
Note
•
When using a DHCP server, also configure the WINS (Windows Internet Name Service)
server.
4) Select [TCP/IP - Get IP Address] and then select [Change Settings].
5) Enter the IP address using the numeric keypad.
Note
•
Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255. However, the first xxx cannot be 127 or any value between 224-255.
•
When you make an entry mistake, press the <C> (Clear) button and enter again.
•
When you would like to move to next without entering all 3 digits, select [save/select next].
6) Select [Save].
7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.
Note
•
Enter address in the format "xxx.xxx.xxx.xxx". xxx should be a numeric value in the range
from 0 to 255. However, the first xxx cannot be 127 or any value between 224-255.
•
Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 248, 252, and
255. However, you cannot use 0 between non-zero values.
•
If you do not wish to set the gateway address, enter "0.0.0.0".
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out a settings list to confirm that the salutation or
WebDAV port and Internet services (HTTP) port are enabled and that the IP address
is configured.
For information about how to print a settings list, refer to [Print Report/List] in Chapter 12, [Machine
Status], of the User Guide.
