Fuji Xerox apeosport-iv C3370, Руководство администратора

Страница: 265 / 889

Print Service Settings
265
T
ools
5
Print Service Settings
In [Print Service Settings], you can configure settings related to the Print feature.
Using CentreWare Internet Services, you can make more detailed settings.
Reference
z For more information, refer to "CentreWare Internet Services Settings" (P.365).
1
On the [Tools] screen, select [System Settings] > [Print Service Settings].
Reference
z For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.156).
2
Select an item to set or change.
Allocate Memory
For each interface, set the memory capacity of the receiving buffer (temporary storage for
data sent from the client).
You can change the receiving buffer capacity according to its use and purpose.Increasing
the receiving buffer capacity may allow a client to be released sooner from an interface.
Important
z If you change the memory capacity, the memory is reset, thus all data stored in memory area is erased.
z You cannot allocate more memory beyond its memory capacity. When you turn the machine on, and the size
set exceeds the total memory size, the system automatically adjusts the memory size.
Note
z When a port is set to [Disabled], the corresponding items to the port do not appear.
z Depending on the amount of data sent from the client, increasing the memory capacity may not change the
time taken to release the client.
PostScript Memory
Specify a value for the PostScript memory capacity in 0.25 MB increments.
Note
z
This feature does not appear for some models. An optional component is required. For more information,
contact our Customer Support Center.
z The maximum amount of memory you can allocate varies according to the amount of free space available in
memory.
ART IV, ESC/P, 201H Form Memory
Displays where to save forms for use with ESC/P-K.
Note
z This feature does not appear for some models. An optional component is required. For more information,
contact our Customer Support Center.
HP-GL/2 Auto Layout Memory
Set the working memory area when HP-GL/2 auto layout memory is used. When the hard
disk is installed, the area is fixed to the hard disk. When the hard disk is not installed, specify
the area for working memory.