Fuji Xerox apeosport-IV 6080, Руководство администратора

Страница: 65 / 705

Replacing Consumables
65
M
ai
n
te
na
nc
e
3
4
Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
5
Insert the front side of the new staple case
into the staple cartridge (1), and then push
the rear side into the cartridge (2).
6
Push the staple cartridge into the finisher
until it clicks into place.
7
Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
remain paused.
Replacing Staple Cartridge (for D2-Staple-Finisher or D2-Staple-Finisher
with Booklet Maker)
When the D2-Staple-Finisher (optional) or D2-Staple-Finisher with Booklet Maker
(optional) is installed and the staple cartridge needs to be replaced, a message
appears on the touch screen. When this message appears, load a new staple case into
the staple cartridge.
This section explains how to replace the staple cartridge in the D2-Staple-Finisher with
Booklet Maker, as an example. You can apply the same procedures for the D2-Staple-
Finisher.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
performance. Use only staple cartridges recommended by Fuji Xerox.
• When the machine is in Energy Saver mode, exit Energy Saver mode by pressing the
<Energy Server> button and the <Machine Status> button on the control panel before you
replace the staple cartridge.
• When you replace the toner cartridge, press the <Machine Status> button and check the
current status for the staple cartridge even when the control panel is lit.
Note • To order a staple cartridge, contact our Customer Support Center.