Fuji Xerox apeosport-IV 6080, Руководство администратора

Страница: 49 / 705

Loading Paper
49
P
ape
r a
nd O
the
r M
edia
2
1
Pull out the Trays 6 or 7 until it stops.
Important • While the machine is processing a job, do
not pull out the tray that the job uses.
• Do not add a new stack of paper on top of
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the
tray, and then load the new stack of
paper.
2
Load and align the edge of the paper against
the right edge of the tray with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
line. It might cause paper jams or
machine malfunctions.
3
Push the tray in gently until it stops.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it
might cause machine malfunctions.
Loading Paper in Tray 8 (Inserter) (Optional)
The following describes the procedure for loading paper in Tray 8 (Inserter) (optional).
Inserter allows you to set paper (blank, copied paper, etc.), which will only be used as
separators and covers, so that the machine does not output on the paper loaded in this
tray.
Note • Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or any other troubles. First, remove the remaining paper from the tray, and then load
the new stack of paper.
1
Hold the center of the paper guides and slide
them to the desired paper size.
2
Load the paper, neatly aligning all edges.
Important • Do not load paper above the maximum fill
line. It might cause paper jams or
machine malfunctions.