Fuji Xerox apeosport-IV 6080, Руководство администратора

Страница: 125 / 705

Common Service Settings
125
T
ools
5
Print-On-Demand Duration (ApeosPort Series Models Only)
Specify the duration for the machine to receive a print job from web applications. Unless the
machine receives full data of the print job within the specified period of time, the machine
does not process the print job.
Specify the time duration between 0 and 255 minutes in 1 minute increments. If you specify
[0], it means that there is no time limit set on the machine for receiving data.
Note • When you send a print job that contains a large amount of data or a print job whose contents
take a while to be processed, transmission may be timed out before the machine receives
the last page of the print job. If transmission is timed out, the print job will be canceled.
Therefore, you should consider the machine usage when you set the time duration.
Energy Saver Settings
You can configure the following settings of Energy Saver mode.
Energy Saver Timers
The Energy Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the machine switches to these modes in the following order to
reduce power consumption.
Last operation on the machine
J
Low Power mode
J
Sleep mode
For more information on the setting procedure, refer to "Energy Saver Mode" (P.23).
Note • You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
„ From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
„
From Last Operation to Sleep Mode
Specify a time period between 1 to 240 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note • Configure the [From Last Operation to Sleep Mode] time to be longer than the [From Last
Operation to Low Power Mode] time.
Energy Saver Deactivation
Set whether to disable the Energy Saver mode fully or partially when exiting the mode.
„ Deactivate All
All devices of the machine exit the Energy Saver mode.
„ Deactivate Partially As Required
Only the devices necessary for the operation exit the Energy Saver mode.
You can select from [Always On] or [When Printing / Job Auto Processing].
Note • Even when [Deactivate Partially As Required] is selected, it is not valid if you set [EtherTalk
Compatible - Port Status] to [Enabled]. For more information on the port setting, refer to the
"Port Settings" (P.161).
Audio Tones
Select whether to sound an alarm when a job ends or a fault occurs.
Control Panel Select Tone
Set the volume to be sounded when a button on the control panel is correctly selected.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].