Setup Menu
127
Syst
em S
e
tt
in
g
s
5
1
Select [Off] or [On].
2
If you selected [On], enter a
recipient's mailbox number with the
numeric keypad, and select [Next].
3
If a passcode is set, enter the
passcode with the numeric keypad, and select [Save].
Note
• If no passcode is set, do not input anything, and select [Save].
F Code
Select whether to use F code communications.
F Code is the transmission procedure set by the Communications and Information Network
Association of Japan and is the T.30 (communication protocol) method for using sub-
addresses that was standardized by the ITU-T.
The F code (sub address) and password use not more than 20 digits 0 to 9,
∗
, and #.
1
Select [Off] or [On].
2
If you selected [On], enter the F
code with the numeric keypad, and
select [Next].
Note
• The F code consists of “0” +
mailbox number. For example, if the mailbox number is 123, the F code is “0123”.
3
Enter the password as required with the numeric keypad, and select [Save].
Note
• You can enter up to 20 digits for the password.
Relay Broadcast
Set the instruction given to a relay station, which is used when the machine is an initiating
station and the registered address number is a relay station for relay broadcast.
When set to [On], set [Relay Station ID], [Broadcast Recipients], and [Print at Relay Station].
1
For a relay broadcast, select [On],
and select [Save].
2
With the numeric keypad, enter the
relay station ID with two digits, then
select [Enter/Change Recipients].
Note
• The relay station ID is the address number for the initiating station (this machine) already
registered on the relay station.
3
With the numeric keypad, enter the
address number (001 to 099) or
group dial number (#01 to #09) for
the broadcast destination, and
select [Add].
Note
• If there is more than one
broadcast destination,
continue by entering another
address number or group dial number, and pressing [Add].
4
To print a document also to the relay station, under [Print at Relay Station] select [On].