6 - 10
INZ-TN2ZKJ-E
6.3 Alarm setting
6.3.1 Setting of alarm values
This mode is used to set the upper or lower limit value to provide an alarm output during measure-
ment. Before changing the alarm setting, set the ON/OFF to OFF.
q
During measurement, press the
MODE
key
to display the User mode.
w
Point the cursor to “Alarm Setting” by
pressing the
or
key. Press the
ENT
key.
e
After the alarm setting CH selection
screen has appeared, point the cursor to
the CH you want to set by pressing
or
key .
Press the
ENT
key.
r
After the alarm item selection screen has
appeared, operate the
or
key until
the cursor is aligned with a desired item
and press the
ENT
key.
(
)
ENT
MODE
ENT
(
)
ENT
Caution
Set the values so that upper limit value > lower
limit value and that (upper limit value
-
lower
limit value) > hysteresis.
