Fuji Electric Time Delta-C FSV-2, Инструкция по эксплуатации

Страница: 38 / 149

-31-
4.8. Channel number
4.8.1. Channel designation
Description
 When selecting 2-path or 2-pipe measurement mode, you need to specify the channel number to set some parameters. In 1-
path/energy measurement mode, there is no parameter need to be specified by channel number.
Channel number
・
CH1 : Settings for path 1
・
CH2 : Settings for path 2
・
CH3 : Settings for calculation
・
CH ALL : Simultaneous settings for path 1 and 2, or path 1 and the calculated value
Related parameters
○
: applicable,
－
:not applicable
2-path 2-pipe
Parameter
CH1 CH2 CH3 CH1 CH2 CH3
Zero adjustment
－ － － ○ ○ －
Damping
－ － － ○ ○ －
Cutoff
－ － － ○ ○ －
Display
○ ○ ○ ○ ○ ○
Range
－ － － ○ ○ ○
Total
－ － － ○ ○ ○
DO
○ ○ ○ ○ ○ ○
Calibration zero
－ － － ○ ○ －
Output setup
Calibration span
－ － － ○ ○ －
Flow unit
－ － － ○ ○ ○
Total unit
－ － － ○ ○ ○
Measurement
setup
Process setting
－ － － ○ ○ －
RAS information
○ ○ ○ ○ ○ ○
Data display
○ ○ － ○ ○ －
Maintenance
mode
Details
○ ○ － ○ ○ －
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.5.1.)
Operation
(example) Check the damping time of CH2. Below is an example for 2-pipe measurement mode.
Key operation Description Display
０．０００ ｍ／ｓ
０．０００ ｍ３／ｈ
▼
Press the key once to display “OUTPUT SETUP”.
OUTPUT SETUP
ENT
▼
Press the
ENT
key once to display “ZERO ADJUSTMENT”.
ZERO ADJUSTMENT
ＣＨ１
▼
Press the key once to display “DAMPING”.
DAMPING
ＣＨ１
ENT
▼
Press the
ENT
key once to blink the second line.
DAMPING
ＣＨ１
▼
Press the key once to display “CH2” on second line.
DAMPING
ＣＨ２
ENT
▼
Press the
ENT
key once to display damping time.
The channel number will blink on the right side of the first line.
DAMPING ＃２
５．０ ｓｅｃ
ESC
Press the
ESC
key twice, and then the key 3 times to return to the
measurement mode.
０．０００ ｍ／ｓ
０．０００ ｍ３／ｈ