Fuji Electric ALPHA7, Руководство пользователя

Страница: 529 / 662

CHAPTER 12 POSITIONING DATA
12-6
Settings
12
12.2 Settings
12.2.1 Positioning Data Specifications
By providing a start positioning signal as assigned from an external address (AD4-AD0),
positioning operation is started according to the settings.
The content of the internal positioning data is as follows:
Item Setting range
Default
value
No. of positioning data addresses 31 (addresses 1-F)
Positioning
data setting
Status (ABS/INC) ABS, INC, CO, CEND, and M code
enable/disable
M code output during positioning/after
positioning completion
INC and M
code
disable
Position (stop position) -2000000000 to +2000000000 [unit amount]
(in increments of 1)
0
Speed (rotation speed) 0.01 to max. rotation speed [r/min]
(in increments of 0.01)
0.01
Stand still timer 0.00-655.35 [sec] (by 0.01s) or 0.000-65.535
[sec] (by 0.001s) (Note 1)
0.00
Acceleration time 0.0-99999.9 [ms] (in increments of 0.1)
However, when 0.0 is set, the amplifier
follows the acceleration time 1 (PA1_37) or
2 (PA1_39) (Note 2) selected by ACC0.
0.0
Deceleration time 0.0-99999.9 [ms] (in increments of 0.1)
However, when 0.0 is set, the amplifier
follows the deceleration time 1 (PA1_38) or
2 (PA1_40) (Note 2) selected by ACC0.
0.0
M code 0 to 0xFF 0xFF
Note 1: Set by the decimal point position of stand still timer (PA2_42).
Note 2: If ACC0 (set to 14) has not been assigned to the CONT signal, acceleration/deceleration
time values follow acceleration time 1 (PA1_37) and deceleration time 1 (PA1_38).