Fuji Electric ALPHA7, Руководство пользователя

Страница: 384 / 662

CHAPTER 6 KEYPAD
Parameter Edit Mode
6-31
6
4
6.7 Parameter Edit Mode
Parameters can be edited in the parameter edit mode.
Press the [MODE/ESC] key until [
pA_0n ] is displayed and press and hold the [SET/SHIFT] key for at
least one second to select parameter editing.
After selecting parameter editing, press the [

] or [

] key to select the number of the desired parameter
to be edited.
Press and hold the [SET/SHIFT] key for at least one second to edit the data.
pA_01
: Parameter page 1
pA_02
: Parameter page 2
pA_03
: Parameter page 3
pA_04
: Parameter page 4
There are parameters that are reflected in operation when settings are changed, and parameters that
are enabled following changes after turning the power off then on again.
If parameters that are enabled after turning the power off then on again are changed, all digits on the
7-segment LED flash twice every 2 seconds to notify the operator.
(1) Parameter page 1
On parameter page 1, relatively frequently used parameters are registered. Changes in most
parameters are reflected on the servo amplifier and servomotor operation immediately.
SET
(1秒以上)
ESC
SET
(1秒以上)
ESC
∧／∨
編集画面
・ 「■表示と編集」の項を参照
番号選択
・ ∧／∨キーで番号を選択
点滅
~ PA_01
~ PA1.01 ~ PA1.99
0
SET
(1 sec. or over)
SET
(1 sec. or over)
No. selection

Select the number with the [
∧
]/[
∨
] keys.

Editing screen

See " ■ Indication and editing".
Flashing