Unless otherwise specified, "raise" and "lower" means
raising and lowering the press ram.
Power source
This press requires 100 VAC
±
10%, 50/60 Hz.
CAUTION:
Connecting a power supply that is different from
this specification may cause a fire or result in bodily injury.
Supplied air pressure
The compressed air pressure used with this press should be 0.2 to
0.5 MPa.
CAUTION:
Use of compressed air at pressures greater than 0.5
MPa may cause the pipes or hoses to burst.
Workbench
WARNING:
Use this press only after securing it on a working
bench that is sturdy enough to support the weight of the press. If it
is not secured, the machine may fall and injure someone.
Acrylic safety cover
WARNING:
Make sure to install the acrylic safety cover on the
mechanical stopper before operation. If you operate the press
without the cover, people may become entangled in the press.
A d j u s t m e n t
o f
t h e
WARNING:
Adjust the mechanical stopper only when the press
mechanical stopper
ram has been raised and is stopped. Make sure that no one is near
the controls. If anyone operates the controls while you are adjusting
the mechanical stopper, you may be injured.
Press operation (1)
Before starting operation, make sure that no one is touching any
part of the press. Especially, when matching mold parts, or when
more than one worker is involved in press preparations, he/she may
be injured. Never touch the mechanical stopper, jig, metal die,
rotation stopper arm, photo sensor light shielding plate, etc.
WARNING:
When two or more people are working near a
press, they must use a sysytem for communicating that leaves no
doubt of their intent. The chances for an accident increase if there is
a misunderstanding about what action will take place next. In a
noisy work environment, hand signals can be used. Failure to
communicate clearly with people in the immediate area can result in
accidents, serious injury and even death.
Press operation (2)
When operating the press, make sure to push both Two-handed
pushbutton switches, one with each hand. If you modify or disable
either of the two switches, or if you set up a foot switch to operate
the press, you may become caught in the jig or metal die and you
may be injured. If you have to operate the press using only one
hand, or by using a foot switch, equip the press with a light beam
interlock device to ensure the safety of the operator. (Make sure to
consult us about these kinds of operations before working this area.)
WARNING:
Pneumatic presses have moving parts that can
crush you and you can die. Make sure to stay clear of any press
while it is moving. Turn of all electrical and pneumatic sources of
power before attempting to adjust the machine.
