Fubag COLD START 300/12, Руководство оператора

Страница: 6 / 18

1. / . Press and keep 3 second , the charger is powered on , the displayer shows blink
of “000”(standby mode).
2. battery type. Select battery type, then charger will give optimized charge process
accordingly.
3. . Switch the charge rate among 2A , 6A ,10А,15А and standby mode. The
display changes after each press and charger will start to work with the set rate 1 second after the
last press.
4. battery voltage. Press this button in standby mode or during charging , the display shows
the battery voltage and keep 3 second .
5. 12 . Press this button during standby mode (blink of “000”), the 12V output socket
on back of the charger is powered on. Press this button again, the socket stops power supply and
the charger is switched to standby mode.
6. . Press this button in standby mode, the charger will give 30 second quick
charge to battery and then give an beep alarm , then start vehicle engine.
7. . ight is on while charging and 12V output working. ight is on
while battery voltage is selected during charging and standby mode.
8. .
- This light is on when any of the operating fault occur.
This light is on while the charger is charging a battery.
- . This light is on while the battery is full.
9. .
Button ON OFF
Button
Button AMP select
Button
Button V output
Engine boost button
Indicators AMP/VOLT L AMP L VOLT
Indicators
FAULT.
- CHARGING.
FULL
Digital display
1
2
3
4
5
6
7
8
9
www.fubag.ru
O m perator's anual
- - 4