DV-HSW4K-41AUD, HDMI 2.0 4x1 Switcher
17
8.2 User Defined EDID Setting
There are five EDID settings that can be customized following the below operations.
1)
Rename the user defined EDID according to the following format.
EC_xx_xxxx_xxx.bin
EC: Represents EDID.
xx: Represents EDID ID. It is 11~15.
xxxx: Represents the video parameter.
xxx: Represents the audio format.
Example: EC_11_720P_LPCM.bin
2)
Power on the switcher, and then connect the switcher to the PC with USB cable.
The PC will automatically detect a U-disk named of “BOOTDISK”.
3)
Double-click the U-disk, a file named of “READY.TXT” to view.
4)
Copy the user defined EDID (such as
EC_11_720P_LPCM.bin
) to the
“BOOTDISK” U-disk.
5)
Reopen the U-disk to check the filename “READY.TXT” this should automatically
become “SUCCESS.TXT”, if yes, the user defined EDID was imported into the
switcher and saved as its corresponding EDID ID successfully.
6)
Repeat the above third to fifth step to copy another user defined EDID to the
“BOOTDISK” U-disk.
7)
Remove the USB cable, connect the adaptor to power on the switcher.
8)
The new EDID also can be invoked via the 4-pin DIP switch directly. The EDID ID
and its corresponding switch status are shown in the below list.
ID
Switch Status
11
1011
12
1100
13
1101
14
1110
15
1111
