WIRE SHELVING
ASSEMBLY INSTRUCTIONS
BOTTOM
OF POST
LEVELING
SCREW
I
TAPERED
FOOT AND BUSHING
RUBBER FOOT_,
\
,
BOTTOM
OF POST
STEM CASTER
(Castor diameter
101mm)
A
FOR USE AS FREE-STANDING,
STATIONARY SHELVING:
B
FOR USE WITH S TEM CASTORS:
Before assembly, lay out storage area accord
ing to desired configuration. "T", "U", configura
tions may be used.
Push swivel stem casters into bottom of
Insert tapered foot bushing into the bottom of
each post. Seat securely by tapping with a rubber
mallet. Screw the adjustable foot levelers into
each bushing. After assembly, stand unit upright
and adjust the foot levelers as required.
each post. Seat securely by tapping with a mallet.
(Note: tapered foot bushing and levelers are not
required when using stem casters.
7
6
5
4
STEP 1.
First perform "A•, "B",
according to the style you have
selected. NOTE: Unit is erected
from the bottom shelf up. Posts
are grooved and numbered in 1"
increments. (Number shown is
approximate height of shelf from
floor not including casters.)
STEP 2.
Select the height of lowest shelf.
STEP 5.
Stand lowest shelf on its side.
Insert posts from bottom into all
four corners so the split sleeves fit
inside each corner. Stand upright.
STEP 6.
At each corner, push shelf firmly
down onto split sleeve. If necessary
for a snug fit, tap corner lightly with
a rubber mallet.
STEP 7.
Select height on the next lowest
shelf. Repeat steps 3 and 4. from
the top of standing unit, slide shelf
onto post at all four corners so the
split sleeve fits inside each collar.
Repeat for remaining shelves.
49
SPLIT
SLEEVE
'
SiW
&:llllllncll llilc:e
1915
ASSEMBLY CAN BE CARRIED
OUT BY ONE PERSON, HOW
EVER ESPECIALLY FOR THE
LARGER SIZE SHELVE� WE
RECOMMEND TWO PEuPLE.
STEP 3.
WIDER
.-END
Hold one half of split sleeve against post with
wider end down. Fit "ridge" inside the split sleeve
into groove and snap split sleeve on. Then snap on
the other matching half of the sleeve.
STEP 4.
Repeat Step 3 at the same height for each of the
three remaining posts.
