FSLaser 36x24, Руководство по установке и настройке

Страница: 8 / 42

[1]
Fire Warning
Laser cutting and engraving systems represent a significant fire hazard due to the extremely high
temperatures generated by the laser beam. While the objective of most cutting and engraving
operations is to vaporize material without burning, it is easy to ignite a flame. Most materials
capable of being cut or engraved are inherently combustible and can easily ignite setting fire to the
machine and threatening its surroundings.
Experience shows that vector cutting with the laser has the most potential to create an open
flame. Acrylic in all its different forms is especially flammable when vector cutting with the laser.
Please also be aware that stacking materials (especially organic materials such as paper) can lead
to increased risk of flame propagation or work piece ignition.
Please read the following warnings and recommendations and follow them closely at all times!

NEVER
leave the laser system unattended during operation.

KEEP
the area around the machine clean and free of clutter, combustible materials,
explosives, or volatile solvents such as acetone, alcohol, or gasoline.

ALWAYS
keep a properly maintained and inspected fire extinguisher on hand. FSLaser
recommends a Carbon Dioxide fire extinguisher or a multi-purpose dry chemical fire
extinguisher. The Carbon Dioxide extinguishers are more expensive than a dry chemical,
but offer certain advantages should you ever need to use an extinguisher. The Carbon
Dioxide extinguisher discharges a clean, easily removable substance that is not harmful to
the mechanics or wiring of the laser system. The dry chemical extinguisher discharges a
sticky, corrosive powder that is very difficult to clean up.

ALWAYS
use air assist when vector cutting.

BE CAREFUL
when vector cutting. Many materials have the potential to burst suddenly
into flames – even materials that may be very familiar to the user. Always monitor the
machine when it is operating.

KEEP YOUR LASER SYSTEM CLEAN
– A build up of cutting and engraving residue and
debris is dangerous and can create a fire hazard. Keep your laser system clean and free of
debris. Regularly remove the cutting grid to clean any small pieces that have gotten stuck
or fallen through.