FSLaser 36x24, Руководство по установке и настройке

Страница: 31 / 42

[24]
Figure 14 - Detail of Optics Sets 2 and 3
1. Mirror 3
2. Mirror 3 adjustment thumbscrews
3. Focus Lens (internal)
Laser Tube Test
In this test we are going to tape a piece of thermal paper between the laser tube aperture and
the beam combiner aperture and then test fire the tube.
1. Make sure that the proper accessories are attached and engaged (water pump)
2. Open the work area cover.
3. Take a piece of thermal paper and tape between the Beam Combiner and mirror 1
with the sensitive (shiny) side facing the laser tube output. Alignment is not critical,
but make sure that there is a large enough white space that can capture the beam
output; the beam is approximately 5mm in diameter and will exit from the center of
the tube.
4. Close the cover.
5. Place the laser into test fire mode ( FS/Z button, toggle until menu reads “Align Mode”.
6. Press the Test Fire button.