PowerBox SC Alloy Crankset Installation Instructions
Introduction
Congratulations on your Full Speed Ahead product. Please read these instructions and follow them for correct use. Failure to follow the warnings and instructions could result in damage to product not covered under warranty,
damage to bicycle; or cause an accident resulting in injury or death. Since specific tools and experience are necessary for proper installation, it is recommended that the product be installed by a qualified bicycle technician.
FSA & Vision assumes no responsibility for damages or injury related to improperly installed components.
Warranty
Full Speed Ahead (FSA) warrants all FSA and Vision products to be free from defects in materials or workmanship for a period of two years after original purchase unless otherwise stated in the full warranty policy. The warranty
is non-transferable and valid to the original purchaser of the product only. Any attempt to modify the product in any way such as drilling, grinding, and painting will void the warranty. For more information on warranty policy
and instructions for completing a warranty claim, check out the Full Warranty Policy found at our website: https://www.fullspeedahead.com/en/technology
Specification
Model Name / Item Number PowerBox SC Cranksets / CK-OS6126 / CK-6126
Assembly
Activation
Calibration
LED Indication
1. Remove the 4 screws
from the top of the
battery cover, and
remove the cover from
the battery housing.
2. Install supplied 2450
battery with “+” side
up. Wait until the LED
flashes green and turns
off. Proceed to next step.
The PowerBox SC was designed and
engineered for ease of use and simple
set-up utilizing an easy “1-2-3” set-up
process:
Note: Before calibrating on each outdoor
ride, it is strongly recommended to leave
the crank at outdoor temperature for 10
minutes.
3. Replace cover onto
Pod.
4. Place 4 screws into holes on the
cover.
5. Use 1.5mm wrench tighten the screws
to a torque 15.3 kgf.cm / 1.5 Nm / 13.3
in.lbs.
1. Rotate the crank.
2. Pod displays yellow LED light then
blue LED light.
3. It is ready to connect to computer.
Red – Low battery
Yellow – Medium battery
Green – High battery
Blue – Stand by
Bluewhite – Calibration
1. Place the non-drive crank into six
o'clock direction.
2. Calibrate via head unit or via phone
application.
3. Once the pod flashes blue white light, the
PowerBox SC is calibrated successfully
and you are ready to ride.
Published – May, 2021. ZSP022.v0 © Full Speed Ahead
