WI-FI 6 ACCESS POINT RESET AND RECOVERY SYSTEM CONFIGURATION GUIDE
www.fs.com
3
The device will automatically start, the main program, print log
NAND read: device 0 offset 0x600000, size 0x200000
2097152 bytes read: OK
Check master boot OK.
NAND read: device 0 offset 0x200000, size 0x200000
2097152 bytes read: OK
Check backup boot OK.
NAND read: device 0 offset 0x2f00000, size 0x800000
8388608 bytes read: OK
No password is required to enter the configuration CLI command line interface
AP>enable
AP#configure terminal
2. Wireless Device Factory Reset
2.1 Networking Requirements
Restore wireless device (AC or AP) to factory settings
2.2 Network Topology
2.3 Configuration Steps
2.3.1 AC Controller Restore Factory Settings
Delete the configuration file config.text ap-config.text
AC#delete config.text
Are you sure you want to delete “config.text”? [Yes/No]y
AC#delete ap=config.text
Are you sure you want to delete “ap-config.text”? [Yes/No]y
AC#reload
Proceed with reload?[no]y
2.3.2 Fat AP Factory Reset
(1)After the device is powered on and running normally, use a small broken needle, insert the reset hole and press for more than 3
seconds (generally press for 5-8 seconds), the device can automatically restore the factory settings.
(2)Or log in to the AP device to use the command
AP(config)apm factory-reset
