Frontier LS2011, Руководство оператора

Страница: 22 / 68

5CS201115OM (rev 00 07/2020)
22
Operating the Sprayer
Pump Safety Precautions
CAUTION: Chemicals can be
dangerous. Avoid injury to operator
or bystanders.
• Read chemical container label for mixing
and handling instructions. A Safety Data
Sheet (SDS) should be supplied by the
chemical dealer and provides proper safety
information. Wear proper clothing and safety
equipment while handling or applying spray
chemicals.
• Wear a full covering of clothing,
• protective goggles and rubber gloves.
• Prohibit all smoking, drinking, and eating
around chemicals.
• When filling tank, never allow end of water
hose to contact chemical mixture.
IMPORTANT: Avoid damage! Clean any spills
immediately with clean water prior to operating
sprayer.
• Do not pump flammable or explosive fluids
such as gasoline, fuel oil, or kerosene.
• Do not pump acids (i.e., acid fertilizer)
with super rollers. For acid fertilizer, Hypro
recommends Silver Series cast with Teflon
rollers (5CS43649 or 5CS43788).
• Do not run pump dry! Do not pump faster or
above maximum recommended speed and
pressure (1200 rpm, 300 psi).
• Do not pump liquids at temperatures higher
than recommended maximum temperature
(60°C, 140°F).
• Disengage PTO, release all pressure and
drain all liquids before servicing pump.
Spraying with the Boom
1. Calibrate the sprayer to achieve the desired
gallons per acre (GPA). Refer to Calibrating
the Sprayer and the Calibration Chart to
determine the correct pressure settings.
2. Connect pump PTO coupler to PTO shaft.
3. Fill tank with water to set pressure and test
for leaks.
4. Prepare to spray by turning section control
valves to OFF and the 3-way valve (A) to
the ON positon as shown.
5. Start tractor and engage PTO. For adequate
spraying pressure and tank agitation, PTO
should be running at or near 540 rpm.
Ensure pump is primed and there are no
leaks in any lines.
6. Use relief valve to adjust sprayer pressure
to pressure rating determined during sprayer
calibration. When opening control valve, it
may be necessary to adjust pressure again.
7. Ensure that tractor PTO is disengaged. Fill
tank with amount of water and chemicals
recommended by chemical being used. After
filling tank, engage pump and allow ample
amount of time for jet agitator to mix water
and chemicals.
NOTE: Do not start sprayer operation
until chemicals and water are mixed for the
recommended time listed on the chemical
instructions.
8. At spraying location, unfold the boom at
locations away from hinges.
Operation
LS2011
LS2015
A
A