Operation
9
WPMAN0142 (Rev. 9/1/2004)
OPERATION
The operator is responsible for the safe operation of
this mower. The operator must be properly qualified
and trained. Operators should be familiar with the
mower, tractor and all safety practices before starting
operation. Read the Safety Rules and Safety Decals on
page 3 through page 8.
This mower is designed for light brush shredding and
grass mowing. It is especially useful in cane, berry,
grape and vegetable crops for mowing and shredding
prunings.
Recommended mowing speed for most conditions is
from two to five mph.
Full chain, rubber, or steel band shielding,
designed to reduce the possibility of thrown
objects, must be installed when operating in popu-
lated areas or other areas where thrown objects
could injure people or damage property. If this
machine is not equipped with full chain, rubber, or
steel band shielding, operation must be stopped
when anyone comes within 300 feet (91.4 m).
Never allow children or untrained persons to
operate equipment.
Keep bystanders away from equipment.
Before servicing, adjusting, repairing or unplug-
ging, stop tractor engine, place all controls in neu-
tral, set park brake, remove ignition key, and wait
for all moving parts to stop.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate
.
ATTACHING MOWER TO TRACTOR
Hitch Point Distance and PTO Clearance
(Figure 1)
Figure 1
. PTO to Mounting Point Distance
The standard drive is intended for use with tractors that
have from 18 to 21" (457 to 533 mm) between the end
of the tractor PTO shaft and the mounting pin holes on
lower lift arms when they are horizontal (refer to Figure
1).
When the PTO/mounting pin distance is less than 18"
(457 mm), the slip tubes of the PTO shaft can bottom
out. When it exceeds 21" (533 mm), there may not be
sufficient engagement when operating on uneven ter-
rain.
When the PTO/mounting pin distance is under 18" (457
mm) or over 21" (533 mm), shorter or longer drives are
available. Contact your Frontier dealer for assistance.
Standard Category 1 mounting pins are used when
attaching the mower to the tractor. Check to be sure
the mounting pins are properly torqued to 300 lbs-ft
(407 Nm).
Attach mower hitch pins to lower tractor lift arms and
secure. Attach tractor top link to mower top clevis. Con-
nect driveline to tractor PTO shaft. Top link adjustment
will be required (refer to instructions on page 11).
The standard 1-3/8" 6B spline driveline with a QD yoke
is used to connect mower to tractor.
Safety is a primary concern in the design and
manufacture of our products. Unfortunately, our
efforts to provide safe equipment can be wiped
out by an operator’s single careless act.
In addition to the design and configuration of
equipment, hazard control and accident preven-
tion are dependent upon the awareness, concern,
judgement, and proper training of personnel
involved in the operation, transport, maintenance
and storage of equipment.
It has been said “The best safety device is an
informed, careful operator.” We ask you to be that
kind of operator.
DANGER
W
W
ARNING
ARNING
CAUTION
CAUTION
18 - 21 in.
(457-533 mm)
