PARTS INCLUDED
A [1] Headboard
B [2]
C [1] Footboard
D [5] Cross Support Slat
E [5] Center Support foot(with adjustable glide)
Qty
10 Pieces
Attached on the Bed
1 piece
TOOLS NEEDED:
Phillips Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
Note:
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
STEP 1
1. Place the Headboard (A) flat on the floor covered with with a protective material to prevent damage.
2. Stand the Headboard (A) upright and hook Side Rails (B) into Headboard (A) as shown in the Diagram I.
Tighten the Allen Bolts(2),with Allen Key(3)
3. Repeat the procedure with the Footboard (C).
STEP 2
1. Locate the Center support foot(E) onto the Cross Support Slat (D) as shown in the Diagram II
2. Place the Cross Support Slat (D) on the inside of the side rails (B).
Screw the ends of the slats to the cleats using Screw (1), as shown in Diagram III.
Allen Head Bolt(0.8cm Dia)
The Hardware is packed with the Headboard (A)
Barrow Bed
Page 1 of 2
Screw (3cm)
NO.
1
DESCRIPTION
Side Rail
3
Allen Key
2
