46027 / 7.5 ft. Nordman Fir Pro Shape Tree
Page 2
2.1
-
Open the carton and take out all the contents. All contents that are listed in the Bill of
Material section on this page should be enclosed. Locate the tree stand and assemble it by
separating the legs of the stand to form an “X” shape (See Fig. 2A). Insert each of the three
screws into the holes on the stand’s middle section, being sure that screws do not extend so far
as to interfere with installation of the tree pole. Place tree stand in desired location.
Fig. 2A
2.2 -
Locate
Tree Section “A”
and remove the protective caps that are on the top and
bottom of the pole (they can be replaced when you re-pack your tree). Insert Tree Section
“A” into the tree stand (See Fig. 2B)
.
Make sure the pole is firmly inserted into the stand, and
then turn all three screws until contact is made with the pole. If Section “A” is not sitting
straight, then simply loosen the screws, adjust tree pole, and retighten the screws.
Fig. 2B
All the branches are connected to the tree’s center pole by metal hinges
(See Figure 2). Remove the packing strap that is around the tree section
and allow the branches to fall into place.
As this is a FRONTGATE
Pro Shape Tree, the leaves will spring into their correct position,
ONLY MINIMAL SHAPING IS NECESSARY!!!