background image

ENG

Jeep Wrangler JKU 4 Door 

(

2007

-

Current

)

 

inner brackets and Foot Rail 

FAJK007 / FAJK008_REV_A00

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

1

IMPORTANT WARNING!

Don’t be a hero and muscle through this without first reading these fitting instructions! Improper installation of this gear may void certain aspects of 

your warranty. 
Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components. 

A complete kit will contain:
1. A Front Runner Mounting System specific to your vehicle 
2. A Front Runner Rack Tray or Load Bar Slats

This document will guide you through the assembly of the mounting system and assist you in fitting the roof rack tray or load bars to your specific 

vehicle.
Please refer to the next page for a list of all the components, quantities and tools required. 

FAJK007 / FAJK008

READ ME FIRST

START HERE!

FRONT RUNNER CAN NOT RECOMMEND A MAXIMUM LOAD CARRYING CAPACITY. PLEASE REFER TO YOUR VEHICLE MANUFACTURER'S RECOMMENDATIONS. IT IS CRITICAL 
THAT  ALL  FRONT  RUNNER  PRODUCTS  BE  PROPERLY  AND  SECURELY  ASSEMBLED  AND  ATTACHED  TO  YOUR  VEHICLE.  IMPROPER  ATTACHMENT  COULD    RESULT  IN  AN 
AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS 
TO YOUR VEHICLE. CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND DAMAGE. THEREFORE YOU 
MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU 
DO  NOT  UNDERSTAND  ALL  OF  THE  INSTRUCTIONS  AND  CAUTIONS,  OR  IF  YOU  HAVE  NO  MECHANICAL  EXPERIENCE  AND  ARE  NOT  THOROUGHLY  FAMILIAR  WITH  THE 
INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

Содержание FAJK002










Отзывы: