Fronius WF 25i Case D200, Руководство по эксплуатации

Страница: 21 / 68

Crane transport The wirefeeder can be transported by crane using its handle.
The maximum load-bearing capacity of the handle is dependent upon the model:
-
D200: 15 kg (33.07 lb.)
- D300: 35 kg (77.16 lb.)
WARNING!
Falling equipment can cause death or serious injury.
▶
Only use a suitable lifting tackle when transporting devices by crane (e.g. belt with
round slings)
▶
The lifting tackle must be undamaged and in perfect condition
▶
Always attach the lifting tackle to both ends of the handle - see diagram below
▶
Do not transport any other loads by the handle apart from the wirefeeder itself
▶
Do not hang from the wirefeeder as it is being transported
Before transporting by crane:
-
feed out the wire electrode, remove the wirespool
- disconnect the torch hosepack and interconnecting hosepack from the wirefeeder
- if present, unplug the coolant connections
21
EN